After this software update, Cyclone Radar will be reset so will require re-commissioning.
To do this, enter a Full RADAR Page and make sure the Cyclone RADAR is selected. Then press;
Firmware update processes are done at your own risk. Before initiating the update process be sure to backup and make copies of all important files.
If the firmware process is interrupted your product may not function properly, therefore do not interrupt the process and ensure the unit is on a reliable power supply. Damage caused by incomplete upgrades will not be covered by Raymarine warranty.
By Downloading the software, you agree to these terms.
|V1.25||Mar 2023||Resolves a production line issue – No end user features or improvements|
This addresses an issue where the Cyclone can remain in Sleep Mode when the MFD is power cycled off and back on again after 60 seconds or more has elapsed.
Note: On certain Cyclones, the unit will not restart once the upgrade has completed, so you’ll see an error message on the Chart Plotter (e.g., “Failed to Update” or “Timeout”). This is Expected. Simply Power cycle the Chart Plotter AND Cyclone off and back on again, and then check in the ‘Network’ tab that the Cyclone has the v1.22 software installed.
|V1.14||Nov 2021||Initial production release|
Some Raymarine products contain software code developed by third parties that are covered by open source GPL and LGPL software license agreements. You can view the third party license agreements by visiting the Manuals section of our website.
To access the open source GPL and LGPL licensed executables click here
This FAQ relates to the following products:
The Quantum, CP100, CP200, CP370, CP470 & CP570 can be upgraded via any of the following Multifunction Displays (MFD):
Note: microSD memory cards used with a/c/e/eS/gS Series MFDs should have a memory capacity of no less than 512MB and no more than 32GB.
Note: To avoid potentially corrupting the data on your Navionics chart card, DO NOT copy software update files to your Navionics chart card and DO NOT back up waypoint/route/track data to your Navionics chart card. MicroSD cards are commonly available in most stores selling consumer electronics products. Waypoint, route, track data, and system configuration data can be stored on a microSD memory card which also contains software update files.
The Radar, SONAR module software is now part of the latest a, c, e, eS, gS Series Multifunction Display (MFD) software download. It contains the following peripherals:
Once the Master MFD has updated, any connected MFD or peripheral will be updated as well.
If you have performed the MFD update recently you may not need to perform this update. Please check if you require the update
The MFD's and peripherals software version may be verified via the command sequence:
[Homescreen] > Setup > Maintenance > Diagnostics > Select Device
If you have issues performing the software update please contact your local Raymarine agent who will be able to assist.